HP 6L Gold, 6L pro manual 40DC Controller removal 1

DC Controller

1Remove the Printer Covers.

2Disconnect the motor connector from the motor (Figure 6-39, callout 1).

3Disconnect the Solenoid connector from the DC Controller (Figure 6-22, callout 1).

4Remove the back sheet metal plate and disconnect the PS202/PS204 connector (Figure 6-29).

5Remove the AC Cable cover and disconnect the AC Cable from the DC Controller (Figures 6-13 and 6-14).

6Tip the printer on its top, with the front facing you.

7Remove the (4) screws (Figure 6-40, callout 1). On some models, one of the screws is a grounding screw. The location of the grounding screw is marked by a “star” etched into the bottom of the DC Controller.

Note	If the model being serviced has a grounding screw with a washer, make sure that the grounding screw
	is replaced in the same location when reinstalling the DC Controller.

1

Figure 6-40DC Controller removal (1 of 3)

EN Bottom assemblies 111