HP C4380, C4390, C4385 manual Integrated wireless Wlan 802.11 network setup

Integrated wireless WLAN 802.11 network setup

Use this section if you want to connect the HP All-in-One to a computer on a wireless network using a wireless router or access point (802.11). HP recommends this method.

To set up the HP All-in-One on an integrated wireless WLAN 802.11 network, you need to do the following:

First, collect all of the required materials.

Next, install the software and connect the HP All-in-One to the wireless router.

See this section:

“What you need for an integrated wireless WLAN 802.11 network” on page 17

“Connect to an integrated wireless WLAN

802.11network” on page 18

Finish setup

What you need for an integrated wireless WLAN 802.11 network

To connect the HP All-in-One to an integrated wireless WLAN 802.11 network, you will need the following:

❑A wireless 802.11 network that includes a wireless router or access point.

❑A desktop computer or laptop with either wireless networking support, or a network interface card (NIC). The computer must be connected to the wireless network that you intend to install the HP All-in-One on.

❑Broadband Internet access (recommended) such as cable or DSL.

If you connect the HP All-in-One on a wireless network that has Internet access, HP recommends that you use a wireless router (access point or base station) that uses Dynamic Host Configuration Protocol (DHCP).

❑Network name (SSID).

❑WEP key or WPA Passphrase (if needed).

Connect to a network 17