HP KAYAK XU800 Post Test Sequence and Post Error, Test, 1.8V, BOARD PLL, Error Code, CPU SOCKET, terminator, Action to Take, correctly installed, 6 Tests and Error Messages

6 Tests and Error Messages

MaxiLife Test Sequence and Error Messages

The following table shows the test sequence carried out, the type of error message, and the action to take.

Test	Error Code	Action to Take
Presence of either a processor or processor	CPU SOCKET	Check that the processor(s), processor terminator and VRM are
terminator		correctly installed.
Control of some voltages: VRMs, 12V, 3.3V,	POWER SUPPLY	Check the power supply cable and connectors, VRM and processor.
1.8V, 2.5V
Check the system board clock generators (PLL).	BOARD PLL	1 Check that the system board is connected
		2 Replace the system board (PLL clock generator).

Post Test Sequence and Post Error

In this phase, MaxiLife waits for any error messages that the BIOS may issue. If such an error occurs, then a screen similar to the following example is displayed. The error code that appears on the LCD status panel is the same as the one that appears on the monitor screen. If the POST issues several error codes, only the last one is visible on the LCD status panel.

ERROR

POST XXXX

The following diagrams show the different BIOS-generated errors.

		“BIOS” ERROR
BIOS
			MaxiLife
			“Spy System
	“read system memory”
			Memory”

System Memory

There is a time-out of 3 seconds before the message is displayed on the LCD status panel and video display.

ERROR

BIOS

LCD Status Panel

109