HP KAYAK XU800 manual Nautr Jr

< btUt

Error Message Summary

The following table summarizes the most significant of the problems that can be reported.

Vt	Nautr Jr
Operating system not found or all	Check whether the disk, HDD, FDD or CD-ROM disk drive is
devices have been checked and no	connected.
operating system has been found	If it is connected, check that it is detected by POST.
	Check that your boot device is enabled on the Setup Security
	menu.
	If the problem persists, check that the boot device contains the
	operating system.
Missing operating system	If you have configured HDD user parameters, check that they are
	correct. Otherwise, use HDD type “Auto” parameters.
Resource Allocation Conflict -PCI device	Clear CMOS.
0079 on system board
Video Plug and Play interrupted or	You may have powered your computer Off/On too quickly and the
failed. Re-enable in Setup and try again	computer turned off Video plug and play as a protection.
System CMOS checksum bad - run	CMOS contents have changed between 2 power-on sessions. Run
Setup	Setup for configuration.
No message, system “hangs”	Check that the main memory modules are correctly set in their
	sockets.
Other	An error message may be displayed and the computer may “hang”
	for 20 seconds and then beep. The POST is probably checking for a
	mass storage device which it cannot find and the computer is in
	Time-out Mode. After Time-out, run Setup to check the
	configuration.

R

If an error occurs during the POST, which prevents the PC Workstation from starting, and before the display device has been initialized, a series of beep codes are issued. Beep codes indicate that a fatal error has occurred and can be reported one after another if there is more than one detected error. In this case, the first detected error is the most important.

127