HP L 5 manual Set Pattern Reference Point Command, ? * p # R

Set Pattern Reference Point Command

The Set Pattern Reference Point command causes the printer to tile patterns with respect to the current cursor position (CAP). This command also specifies whether the pattern rotates with the print direction or remains fixed.

?* p # R

# = 0	-	Rotate patterns with print direction
1	-	Keep patterns fixed
Default	=	0
Range	=	0,1 (values outside the range are ignored)

	A value field of 0 rotates the patterns with changes in the print
	direction (see Print Direction command). For a value field of 1,
	patterns remain fixed for changes in print direction.
	The default pattern reference point is the upper left corner of the
	logical page at the top margin (position 0,0). If the Set Pattern
	Reference Point command is not set, the pattern is tiled with respect
	to the default reference point.
Note	All patterns are rotated for changes in orientation, but the pattern
	reference point remains the same (refer to “Logical Page Orientation
	Command” in Chapter 5 of the PCL 5 Printer Language Technical
	Reference Manual).
	This command applies to user-defined, shading, and cross-hatch
	patterns.

EN The PCL Print Model 5-43