HP L 5 manual End Raster Graphics Command, ? * r C

End Raster Graphics Command

The End Raster Graphics command signifies the end of a raster graphic data transfer.

?* r C

Receipt of this command causes 5 operations:

•Resets the raster compression seed row to zeros.

•Moves the cursor to the raster row immediately following the end of the raster area (if a source raster height was specified).

•Allows raster commands which were previously locked out to be processed.

•Sets compression mode to 0 (no compression).

•Defaults the left graphics margin to X-position 0.

Note	This command is a modified version of the ?*rB End Raster
	Graphics command. The newer version (?*rC) performs two
	additional operations: it resets the compression mode to 0 and
	defaults the left graphics margin to 0.
	This command (?*rC) is not supported by the HP LaserJet III or the
	HP LaserJet IIID printers. Use the ?*rB End Raster Graphics
	command to terminate raster graphic data transfers for these printers.
	Refer to the “PCL Feature Support Matrix” in Chapter 1 of thePCL 5
	Comparison Guide for specific printers which support these
	commands.

EN Raster Graphics 6-35