HP L 5 manual Raster Graphics Example

Raster Graphics Example

To transfer an unencoded arrow-shaped raster graphic image (see Figure 6-7) in the shape of an arrow, perform the following steps (notice the well-behaved raster sequence is utilized):

1Position the cursor:

?*p300x400Y	Move the cursor to PCL Unit position
	(300, 400) within the PCL coordinate
	system.

2Specify Raster Presentation Mode 0:

?*r0F	Print raster graphics in the orientation of
	the logical page.

3Specify the raster graphics resolution:

?*t75R Set raster resolution to 75 dpi.

4Specify the raster graphics height:

?*r32T	Specify a raster height of 32 pixels (32
	rows of raster data).

5Specify the raster graphics width:

?*r32S Specify a 32-pixel raster width.

6Specify the left raster graphics margin:

?*r1A	Set the left graphics margin to the current
	X position (300).

7Specify the Y offset:

?*b0Y	This specifies a Y offset of 0 (this
	command is not necessary here but
	shows the proper command sequence).

6-38 Raster Graphics EN