HP R4010US, R4000, R4001XX, R4003XX, R4012US Set the modem to ignore dial tones, Select Properties

Modem and Networking

■Check the telephone number you are dialing and the response of the remote modem.

Dial the telephone number on the telephone, make sure there is a response from the remote modem, and then hang up.

■Set the modem to ignore dial tones.

If the modem receives a dial tone it does not recognize, it will not dial and will display a No Dial Tone error message.

To set the modem to ignore all dial tones before dialing:

1.Select Start > Control Panel > Printers and Other

Hardware > Phone and Modem Options.

2.Select the Modems tab.

3.Select your modem.

4.Select Properties.

5.Select the Modem tab.

6.Clear the check box for Wait for Dial Tone Before

Dialing.

7.Select OK > OK.

If you continue to receive the No Dial Tone error message after clearing the Wait for Dial Tone Before Dialing check box:

1.Select Start > Control Panel > Printers and Other

Hardware > Phone and Modem Options.

2.Select the Dialing Rules tab.

3.Select your current modem location setting.

4.Select Edit.

5.Select your current location from the Country/region drop-down list. (If you select a country or region that is not supported by the modem, the Country/region selection for USA or UK is displayed by default.)

6.Select Apply, and then select OK.

10–8 Hardware and Software Guide