RC3000 Antenna Controller | Chapter 3 | Detailed Operation |
3.3.1.3.6 Elevation | Pulse Drive |
|
|
|
| |
|
|
|
|
| ||
| SCALE:2406 |
| CONFIG_EL PULSE |
| ||
|
| CW:49451 | FAST/SLOW: | 50 | COAST: 5 |
|
|
| CCW:16085 | MAX ERROR: | 3 | RETRY: 3 |
|
| ELEV SCALE |
| ||||
SCALE: | ELEV SCALE | |||||
The antenna_elev_constant configuration item specifies the approximate number of pulses measured per radian of elevation travel. See the installation section for calculation of the elevation pulse scale factor.
The antenna_elev_constant is used by inclined orbit tracking and autopeak algorithms for determining amount movement (in pulses).
UP: | ELEV UP PULSE LIMIT <100 - 65535> |
DOWN: | ELEV DOWN PULSE LIMIT <100 - 65535> |
The ip_elev_pulse_limit and down_elev_pulse_limit configuration items specify the range of elevation motion measured in pulses. These items are used by the tracking and autopeak algorithms to place bounds on the area searched. These values are also used to determine the validity of stored satellite data.
FAST/SLOW: | SET THRESHOLD <0 - 999 PULSES> |
During an automatic move, the elev_fast_slow_pulse_threshold configuration item is used to set the number of pulses before a target position is reached, when the controller switches the speed of the drive from fast to slow.
MAX ERROR: | SET MAXIMUM ERROR <0 - 10 PULSES> |
The elev_max_position_pulse_error configuration item sets the maximum acceptable error between the final resting position and a target position during an automatic move.
COAST: | SET COAST RANGE <0 - 999 PULSES> |
During an automatic move, the elev_coast_pulse_threshold configuration item sets the number of pulses before the target position is reached where the drive will be deactivated. The idea is to deactivate the drive and let the antenna coast into position. If prior to the initiation of the move operation, the total number of degrees that the actuator has to move to reach the target position is less than the 'Coast Threshold, the drive will be deactivated when its position is within 'Max Error of the target position.
TRIES: | SET MAX NUMBER OF TRIES |
The elev_auto_move_max_retry_pulse_cnt configuration item sets the maximum number of attempts which will be made to hit a target position (within Max Error - described above) during an automatic move based on potentiometer feedback.
3.3.1.3.7 Elevation Drive Monitoring
This group performs the same functions for the elevation axis as described in 3.3.1.8 (Azimuth Drive Monitoring)
114
