RC3000 Antenna Controller

Chapter 3

Detailed Operation

3.3.1.2.6 Autopeak

This screen defines how the autopeak functions of the LOCATE mode are configured.

 

ON:1

SRCH_AZ:

3

CONFIG-AUTOPEAK

 

 

SIG:1

SRCH_EL:

3

SCAN_RG: 2

 

 

BAND:1

SRCH_TH:200

SCAN_TH:200 TILT:0

 

 

AUTOPEAK <0>DISABLED <1>ENABLED <2>+PEAK

 

ON:

AUTOPEAK <0>DISABLED <1>ENABLED <2>+PEAK

The autopeak_enabled item defines if autopeak (SCAN or SEARCH) movements are to be performed as part of the LOCATE movement.

If disabled (selection 0), the LOCATE procedure will move to the nominal target position without attempting an autopeak procedure.

If enabled (selection 1), the Azimuth Scanning (3.2.2.3.3) or Spiral Search (3.2.2.3.4) Autopeak movement will be attempted.

If selection 2 (+PEAK) is chosen, the terminal peakup movement described in 3.2.2.3.5 will also be enabled. NOTE: Verify that the required conditions for terminal peakup (3.2.2.3.5) are present before selecting this option.

SIG:

SIGNAL SOURCE <1>RF <2>SS1 <3>SS2

The autopeak_signal_source item defines which of the three signal source channels will be used to recognize if a satellite is present.

BAND:

BAND <0-C 1-Ku 2-CK 3-L 4-X 5-Ka 6-S>

The autopeak_band item defines what RF band the receiving equipment is set for during an autopeak. The band used will affect the size of steps used for autopeak movements.

SRCH_AZ:

SPIRAL SEARCH AZIM LIMIT <1-15 DEGREES>

SRCH_EL:

SPIRAL SEARCH ELEV LIMIT <1-15 DEGREES>

The search_azim/elev_limit items define the area that the spiral search pattern is allowed to search to recognize a satellite. If a satellite is not recognized after searching the area defined by these limits, the spiral search will return to the nominal target position. The larger the limits, the longer time a search might take. If the limits are too small to account for azimuth target inaccuracy due to heading error or to account for the amount of elevation movement an inclined orbit satellite may exhibit, the spiral search may quit before moving over the satellite.

SRCH_TH:

SPIRAL SEARCH THRESHOLD <0-999>

This threshold item defines what the minimum signal strength indication is required for the search procedure to recognize that a satellite is present.

SCAN_RG:

SCAN RANGE <1-15 DEGREES>

The scan_range item defines how many degrees to either side of the nominal azimuth target the scan autopeak operation will search.

TILT:

POL TILT COMPENSATION <0>OFF <1>ON

This item specifies if additional movements are to be made during the LOCATE function in order to characterize the pitch and roll of the platform. Refer to section 3.2.2.3.6 for discussion of this feature.

106

Page 114
Image 114
HP RC3000 manual Autopeak 0DISABLED 1ENABLED 2+PEAK, SIG Signal Source 1RF 2SS1 3SS2, Srchth Spiral Search Threshold