Intel 5800/120Ld manual Management Workstation Application B-5

7.Set the SG information as follows. (The items with * marks must be entered.)

!Computer Name* Enter the server name.

!IP Address*

Enter the IP address of the server.

!Subnet Mask*

Enter the subnet mask of the server.

!Default Gateway*

Enter the IP address of the default gateway on the network.

!Management PC (1)(3)’s IP*

Enter the IP address of the management PC with MWA installed. (1)(3) shows priority.

!Pass-phrase*

Enter the pass-phrase that is used for communication between server - RomPilot and management PC - MWA.

!Community Name (SMC supported servers)

Enter a key for authentication used between server SMC and management PC - MWA (community name for SNMP trap). Default value is public.

!Magic Number (SMC supported servers)

Enter code key that is used between server - SMC and management PC - MWA.

!Recovery Mode (SMC supported servers) Select automatic or manual.

If automatic is selected, SMC automatically executes recovery processing when a fault occurs. It will be accepted as an instruction from MWA.

!SOS Alert (SMC supported servers) Select SOS Alert enabled or disabled.

If disabled is selected, SMC will not send an SOS message to MWA when a fault occurs.

8.Select Save Setting. SG information is saved on the floppy disk. You will need this floppy disk (called the SG information FD) to register the server on the management PC MWA.

Note: For details on Network setup, see

EXPRESSBUILDER online help.

Management Workstation Application B-5