Intel 5800/120Ld Configuring System Board Jumpers, System Board Jumpers Configuring Your System

If you want to remotely configure the array (from a PC client); increase array capacity online; or monitor statistics on disk and controller activity, you must install the array manager provided with your RAID subsystem. Increasing array capacity is covered in the user's guide shipped with the option.

Configuring System Board Jumpers

Before You Begin

Only a qualified technical person should perform the procedures in this section.

!CAUTION

Electrostatic discharge (ESD) can damage the system board. Modify the system board only at an ESD workstation. Otherwise, wear an antistatic wrist strap attached to chassis ground.

The system board jumpers enable you to set specific operating parameters for your system. A jumper is a small plastic-encased conductor (shorting plug) that slips over two jumper pins.

The “System Board Jumpers” illustration (Figure 3-1) shows the location of the system board jumpers (A). Table 3-3 “System Board Jumper Configurations” lists the system board jumpers and their factory default settings.

A

Figure 3-1. System Board Jumpers

3-20 Configuring Your System