6.Remove the screw securing the filler panel removed in the previous step to the right device rail. Save the right device rail. See Figure
Figure 4-28. Removing the slide rail from the Filler Panel
7.Remove the device from its protective wrapper and place it on an antistatic surface. Record the drive model and serial number in the equipment log.
8.Set any drive jumpers or switches before you install the drive. See the documentation that comes with the device for jumper or switch information.
Note: If the drive comes with drive rails, do not use them. Remove any rails already attached.
9.Position the right device rail along the right side of the device so that the four holes in the device rail match the four holes located in the side of the device. Attach the right device rail to the device with four screws as shown in Figure
