Register Description

4.8.23SCICMD – SCI Error Command Register (Device #0)

Address Offset:

67h

Default Value:

00h

Access:

Read/Write

Size:

8 bits

This register enables various errors to generate a SCI Hub Interface Special cycle. When an Error Flag is set in the ERRSTS register, it can generate a SERR, SMI, or SCI Hub Interface Special cycle when enabled in the ERRCMD, SMICMD, or SCICMD registers respectively.

Note: An error can generate one and only one Hub Interface Error Special cycle. It is software's responsibility to make sure that when an SCI error message is enabled for an error condition, SERR and SMI Error Messages are disabled for that same error condition.

Bit

Description

 

 

7:4

Reserved

3SCI on GMCH Thermal Sensor Trip:

1: An SCI Hub Interface Special cycle is generated by GMCH when the Thermal Sensor Trip requires an SCI. A Thermal Sensor Trip Point cannot generate more than one special cycle.

2Reserved

1SCI on Multiple-bit ECC Error:

0: This system does not support ECC, this field must be set to 0.

0SCI on Single-bit ECC Error:

0: This system does not support ECC, this field must be set to 0.

D15343-003

69

Page 69
Image 69
Intel D15343-003 Scicmd SCI Error Command Register Device #0, SCI on Gmch Thermal Sensor Trip, SCI on Single-bit ECC Error