JBL 201, SDP-5, Home Theater System manual Tilt EQ, Loudness, To +3.0dB

AUDIO CONTROLS

JBL Synthesis

AUDIO CONTROLS (continued from page 4-3)

MAIN MENU

MODE ADJUST AUDIO CONTROLS SETUP

AUDIO CONTROLS

BASS	+0.0dB
TREBLE	+0.0dB
TILT EQ	+0.0dB
LOUDNESS	ON
BALANCE	<>
FADER	<>
ZONE2 BALANCE	<>

-3.0 to +3.0dB

MAIN MENU

MODE ADJUST AUDIO CONTROLS SETUP

AUDIO CONTROLS

BASS	+0.0dB
TREBLE	+0.0dB
TILT EQ	+0.0dB
LOUDNESS	ON
BALANCE	<>
FADER	<>
ZONE2 BALANCE	<>

ON

OFF

TILT EQ			-3.0 to +3.0dB
AUDIO CONTROLS	TILT EQ

Controls the amount of tilt equalization applied to the Main Zone audio output connectors labeled Front L/R, Center, and Subwoofer. This parameter setting affects the entire frequency spectrum with a hinge point at 1kHz. As the setting is increased, frequencies higher than 1kHz are boosted, while frequencies lower than 1kHz are simultaneously cut. As the setting is decreased, frequencies higher than 1kHz are cut, while frequencies lower than 1kHz are simultaneously boosted. The graph shown on the left of the next page illustrates the frequency response of TILT EQ parameter settings.

Note:

When the Zone 2 command bank is activated, pressing the remote control Blue button sets the BASS, TREBLE, and TILT EQ parameters to +0.0dB.

LOUDNESS			ON, OFF
AUDIO CONTROLS	LOUDNESS

Controls the amount of low-frequency boost that is automatically applied to the Main Zone audio output connectors labeled Front L/R, Center, and Subwoofer. When set to ON, loudness compensation is automatically applied based on volume level. As volume level increases, the amount of boost automatically decreases. The loudness contour is optimized for sources calibrated to THX reference levels. When set to OFF, no loudness compensation is applied. The graph shown on the right of the next page illustrates the frequency response that is automatically applied when the LOUDNESS parameter is set to ON and Main Zone volume level is adjusted.

4-4