JBL 201, SDP-5 manual Restoring FACTORY-DEFAULT Settings, To restore factory-default settings

Troubleshooting & Maintenance

JBL Synthesis

RESTORING FACTORY-DEFAULT SETTINGS

When factory-default settings are restored, all parameters and user-defined values are restored to their factory-default settings. Before restoring factory-default settings, it is recommended to record all user-defined settings on the installation worksheet that begins on page A-14.

To restore factory-default settings:

1.Record all user-defined settings on the installation worksheet that begins on page A-14. When factory-default settings are restored, all parameters and user-defined values are restored to their factory-default settings.

2.If the SDP-5 is powered on, press the front panel standby button or the remote control Off button to activate standby mode and deactivate the SDP-5. If the SDP-5 is in standby mode, proceed to step 3.

3.Press the front panel standby button or the remote control On button to deactivate standby mode and activate the SDP-5.

4.Quickly press and hold the front panel or remote control Mute button until the FACTORY SETTINGS menu shown below opens on the on-screen and front panel displays.

FACTORY SETTINGS

EXIT

RESTORE DEFAULTS

The Mute button must be pressed within 2 seconds of activating the SDP-5. If the message "MUTE ON" appears on the on-screen and front panel displays when the Mute button

is pressed, too much time has passed. If this occurs, begin again with step 2.

5. Press the remote control Menu and arrows to highlight the desired option. Highlight the RESTORE DEFAULTS option to restore factory-default settings. Highlight the EXIT option to close the FACTORY SETTINGS menu without restoring factory- default settings.

6.When the desired option is highlighted, press the Menu arrow to select this option.

•If the RESTORE DEFAULTS option was selected, the FACTORY SETTINGS message shown below appears on the on-screen and front panel displays. When this message appears, press a front panel or remote control button to restart the SDP-5.

FACTORY SETTINGS	FACTORY SETTINGS
EXIT	HAVE BEEN RESTORED
RESTORE DEFAULTS	PRESS ANY KEY
	TO RESTART

•If the EXIT option is selected, the FACTORY SETTINGS menu will close and the two-line status (2-18) opens on the on-screen and front panel displays.

6-4