JBL 201, SDP-5, Home Theater System manual Dacs Calibration, Channel Dolby Digital Dts-ES, Sources

SDP-5

SETUP

MAIN MENU

MODE ADJUST AUDIO CONTROLS SETUP

SETUP

INPUTS

SPEAKERS

REAR PANEL CONFIG DISPLAYS VOLUME CONTROLS TRIGGER

LOCK OPTIONS

SPEAKER SETUP

CUSTOM SETUP SYNTHESIS 7CH SETUP SPEAKER DISTANCES LEVELS CALIBRATION

		R	SR	RR
		80Hz	80Hz	80Hz
		C
		80Hz
	M	L	SL	RL
	SUB
80Hz		80Hz	80Hz	80Hz

LEVELS CALIBRATION

INTERNAL NOISE TEST DACS CALIBRATION

BASS PEAK LIMITER

DACS CALIBRATION

FRONT LEFT	+0.0dB
CENTER	+0.0dB
FRONT RIGHT	+0.0dB
SIDE RIGHT	+0.0dB
REAR RIGHT	+0.0dB
REAR LEFT	+0.0dB
SIDE LEFT	+0.0dB
SUBWOOFER	+0.0dB

DACS CALIBRATION

SETUP SPEAKERS LEVELS CALIBRATION DACS CALIBRATION

Opens the DACS CALIBRATION menu shown above, which can be used to adjust output levels while DACS calibration is conducted. DACS calibration requires an external calibration source, such as an audio calibration disc or, in JBL Synthesis systems, the DACS® (JBL Digital Acoustical Calibration System). An audio calibration disc can be used with the DACS.

To optimize systems that include DACS and a JBL Digital Equalizer:

1.Connect the DACS Signal Generator left and right output connectors labeled EVP-1 to the SDP-5 analog audio input connectors labeled 1. These connectors are active in the TAPE input.

2.Set the master volume level to 0dB.

When DACS calibration is conducted, the SDP-5 activates a listening mode based on the Main Zone input source that is present. The table in the next column indicates the listening mode that is activated for each input source. When a listening mode is activated during DACS calibration, it retains its factory-default settings, ignoring custom settings that might have been selected on the corresponding listening mode menu. Custom settings will be restored after DACS calibration is complete.

2-Channel	Dolby Digital	dts(-ES)
Sources	Sources	Sources
DOLBY PLII MOVIE	DOLBY DIGITAL*	dts(-ES)*

*These listening mode names differ depending on the input source, the speaker configuration, and certain parameter settings.

This will provide the correct signal path and reference output level.

3-41