Dts-ES 2-CHAN | JBL SDP-5, Home Theater System, 201 guide

MODE ADJUST

dts(-ES)

MODE ADJUST dts-ES

JBL Synthesis

dts(-ES) 2-CHAN

MODE ADJUST dts-ES2-CHAN

•Designed for playback of 5.1- and 6.1-channel dts(-ES) sources.

•Decodes 5.1 matrix or 6.1 discrete channels from dts(-ES) sources. The six main channels are full-frequency. The .1 channel, often referred to as LFE information, has a limited frequency range of 120Hz.

•Appropriate for dts(-ES) film sources.

•Designed for converting 5.1- or 6.1-channel dts(-ES) sources into 2-channel LOGIC7-encoded output signals.

•Sends downmixed 5.1- or 6.1-channel dts(-ES) input signals to the front speakers and subwoofer.

•Recommended for recording purposes.

Option/	Default	Possible
Parameter	Setting	Settings

LFE MIX	+0.0dB	-10.0 to +0.0dB

ES DECODING	AUTO	AUTO, ON, OFF

OUTPUT LEVELS

CUSTOM

Listening mode menu option and parameter descriptions begin on page 5-28.

Option/	Default	Possible
Parameter	Setting	Settings

CENTER MIX	+0dB	-25 to +5dB

SURROUND MIX	+0dB	-5 to +5dB

CNTR DLY SAMPLES	+0	-127 to +127

MASTER LEVEL	+0dB	-5 to +5dB

LFE MIX	+0.0dB	-20.0 to +0.0dB

ES DECODING	AUTO	AUTO, ON, OFF

SUB LEVEL	+0dB	OFF, -30 to +12dB

CUSTOM

Listening mode menu option and parameter descriptions begin on page 5-28.

5-26

Image 129

JBL SDP-5, Home Theater System, 201 manual Dts-ES 2-CHAN

Contents

JBL SIS Products Group Introduction Introduction SetupGetting Started Basic Operation Troubleshooting & Maintenance Mode AdjustAudio Controls Appendix English Important Safety Instructions Español Instrucciones DE Seguridad Importantes Importanti Norme DI Sicurezza Dansk Vigtig Information OM Sikkerhed Norsk Viktig Informasjon OM Sikkerhet DE Auspacken und Überprüfung US Unpacking and InspectionES Desembalaje e inspección FR Contenu de l’emballage et inspection Getting Started About the SDP-5 Getting Started Highlights Do Not Installation Considerations To replace the remote control batteries Remote Control Battery Installation Basic Operation Front Panel Overview Standby ButtonFront Panel Display Mode and Buttons Volume KnobTo use the volume knob to adjust Main Zone volume level To use the volume knob to adjust Zone 2 volume level Main Zone Input Selection Buttons Mute ButtonMain Zone Off Button Zone 2 Input Selection Buttons AC Input Connector Power SwitchDigital Audio Input Connectors S/PDIF Digital Audio Output Connector S/PDIF Rear Panel Overview from Zone 2 Audio Output Connectors Main Zone Video Output Connectors Video Input ConnectorsZone 2 Video Output Connectors RS-232 Connectors Main Menu Remote Control OverviewOperation Considerations Menu Navigation Menu Options Arrow Navigation FunctionsParameter Drop-Down Menus Menu Parameters To select the desired setting on a parameter drop-down menu To adjust a parameter setting with a horizontal bar graphHorizontal Bar Graphs Command Bank Activation Command MatrixTo activate the Zone 2 or Shift command bank Button Main Zone Shift Scroll upward Increase Decrease Adjust the Audio DVD2 Basic Operation Shift-dts Shift-DOLBYShift-THX Understanding the Zones Main Zone Two-Line Status TWO-LINE StatusZone 2 Two-Line Status Status Menus Status menus Parameter Possible Settings 2CH StatusDolby D Status 1a Bypass Status Dts-ES Status Digital Status 2CH Bypass Status BIT Rate EncodingCenter MIX LVL Channels Input Type InputMIX Room Mode Basic Operation Setup Volume Controls Rear Panel ConfigDisplays Inputs Lock Options Input Setup Changing Input Names Name Edit Input NameTo customize the name of the selected input To restore the factory-default name of the selected input Restore Default Name Assigning Audio & Video Input Connectors Digital COAX-1 to 4, OPTICAL-1 to 4, NonePlease note the following Assigning Audio & Video Input Connectors from Auto Anlg in LVL Manual Auto Gain18 to +12dB Level Meters VideoCOMPOSITE-1 to 5, S-VIDEO-1 to 5, None Component Selecting Preferred Listening Modes Selecting Preferred Listening Modes from When the 2-CH parameter is set to USE Last Dolby D When the Dolby D parameter is set to USE Last Dts-ES When the dts-ES parameter is set to USE Last Main Advanced Configuring Advanced Zone Settings Input Select Digital Analog Auto Input Select Parameter Settings ON, OFF CH Anlg BYP Video Video OSD Component OSD DIGITAL, ANLG, Dmix ZONE2 ZONE2 in Parameter Settings DigitalAnlg Analog Dmix Downmix Speaker Setup Custom Speaker SetupsDetermining Crossover Points Highpass Filter Default Possible Parameter Setting Settings Front L/RFULL, 30Hz to 120Hz, THX 80Hz FULL, 30Hz to 120Hz, THX 80Hz, None Center Side L/R Rear L/R Subwoofer BGC Boundary Gain Compensation THX ULTRA2 SUB ASA Advanced Speaker Array THX ULTRA2 SUB OFF ON, OFF BGC ASA Apart Synthesis 7-CHANNEL Speaker Setups THX 80Hz, None JBL Synthesis 7-Channel Speaker Setups from Measuring Speaker Distances Side Left & Right Measuring Speaker Distances fromRear Left & Right Units Internal Noise Test Calibrating Output Levels Internal Noise Test from Dacs Calibration Channel Dolby Digital Dts-ESSources 18.0 to +12.0dB Front Left & Right Side Left & Right Rear Left & RightSubwoofer CAL Noise Bass Peak Limiter SUB Limiter SUB Limit ADJ75 to 120dB Rear Panel Config Stereo InputsST. & 1 5.1 Anlg ST. & 2 5.1 Anlg Sync Delay Display Setup To customize the name of the SDP-5 Edit Custom Name Status ON-SCREEN Display Setup Format Position Remote State Background Status Front Panel Display SetupBrightness 100%, 75%, 50%, 25% Main PWR on Volume Control SetupMute Level Zone PWR on Selecting the Setup menu Trigger option opens Trigger Setup menu shown at the right, which canBe used to configure the trigger output connector Program Operation Parameters ON, OFF Lock Options ModesAudio Cntrl Setup Audio Controls Audio Controls Default Possible Parameter Value SettingsBass Treble Bass Parameter Settings Treble Parameter Settings Tilt EQ LoudnessTo +3.0dB Tilt EQ Parameter Settings Loudness Parameter Settings Fader BalanceZONE2 Balance To to R Mode Adjust Mode Adjust Listening Mode ActivationListening modes can be activated with Mode and Buttons Preferred Listening Mode Selection ParametersMode Family Selection Buttons Listening Mode Descriptions Option Default Possible Parameter Setting Settings L7 FilmL7 TV L7 Music Surr L7 Music Parameter Setting Settings Option DefaultDolby Plii + THX Dolby Plii Movie Dolby Plii Music Dolby PRO LogicOption Parameter Dts NEO6 Music Dts NEO6 Film Concert Hall Nightclub Cathedral Church To calibrate the Panorama listening mode PanoramaPanorama Calibration Speaker Angle SourceListener POS Party Channel+0dB OFF, -30 to +12dB Mono Logic Mono SurroundMono L7 TV L7 Film THX, 5.1 THX ULTRA2, & 5.1 THX SurEX L7 Music THX SurEX Channel Channel Surround EX-Encoded Dolby Digital & Dolby Digital EX THX Music Dolby Digital Digital EX Flagged Digital EX Non-Flagged Channel Channel Dolby 2-CHANNEL Mono Mono Surr Dts-ES Decoding Channel dtsDts Dts-ES L7 Music Dts-ES L7 Film Dts THX ULTRA2 & dts-ES THX +0.0dB 10.0 to +0.0dB Dts THX Music Dts-ES 2-CHAN Dts-ES 2CH Bypass 1a Bypass Spkr Enhance Bass ContentAcademy Filter Auto Azimuth Calibration Bass RTCenter Depth Center MIX Custom VS Preset Listening Mode Menu Option & Parameter DescriptionsDimension Effect LVL EX Decoding Front SteeringInput Balance Output Levels Reset Mode PRE-DELAYPanorama RE-EQUALIZER Size Reset ModeRolloff Sound Stage SUB Level Speech DetectSurr Rolloff Surround DLY Surround EX Surround MIXVocal Enhance Troubleshooting & Maintenance Troubleshooting Routine Maintenance SDP-5 is powered on, but there is no videoRF interference is present in the audio or video SDP-5 is exhibiting erratic behavior To restore factory-default settings Restoring FACTORY-DEFAULT Settings Appendix Audio Input & Output Connectors SpecificationsMain Zone Audio Performance Zone 2 Audio Performance Video Input & Output Connectors Specifications are subject to change without noticeComposite & S-video Performance Component Video Performance Menu Tree Declaration of Conformity Input Setup DVD1 DVD2 SAT VCR Tuner AUX JBL None DVD1 Component Menu Tree from page A-7 Are automatically set Menu Tree from page A-9 Party Output Levels Custom Channel SUB Level Menu Tree from page A-11 Surround DLY DVD1 DVD2 SAT VCR Tuner AUX Installation Worksheet Input Setup Settings Volume Control Display SetupSetup Trigger Setup