JBL 201, SDP-5 TWO-LINE Status, Main Zone Two-Line Status, Zone 2 Two-Line Status, Status Menus

SDP-5

Basic Operation

TWO-LINE STATUS

The two-line status provides information about the zone from which the SDP-5 last detected a change in status. The Main Zone two-line status appears when the SDP-5 detects a Main Zone change, and the Zone 2 two-line status appears when the SDP-5 detects a Zone 2 change.

The ON-SCREEN DISPLAY menu STATUS (3-49) parameter can be used to control the length of time for which the two-line status appears on the on-screen display. The ON-SCREEN DISPLAY menu POSITION parameter (3-50) can be used to control the position of the two-line status on the on-screen display.

Note:

When the display device is connected to a component video output connector and the MAIN ADV menu COMPONENT OSD parameter (3-23) is set to OFF, the display device does not show the on-screen display, including the two-line status.

Main Zone Two-Line Status

The Main Zone two-line status shown at the	DVD1		%!D VOL
right indicates the current input, listening	L7	FILM	-37dB
mode, input source, and volume level selected

in the Main Zone. It appears on the on-screen and front panel displays when the SDP-5 detects a Main Zone change.

Zone 2 Two-Line Status

The Zone 2 two-line status shown at the right	DVD1	%!D VOL
indicates the current input, input source, and	ZONE2	-37dB
volume level selected in Zone 2. It appears on

the on-screen and front panel displays when the SDP-5 detects a Zone 2 change.

STATUS MENUS

When the Shift command bank is activated, pressing the remote control Stat button opens the STATUS menu for the current input source, which contains parameters that provide information about the current input source and listening mode. STATUS menus are available for 2-channel, Dolby Digital, dts(-ES), and analog input sources.

Unlike most other menus, STATUS menus cannot be opened through the selection of menu options. Rather, the remote control Shift, Stat command must be performed.

To open and navigate the STATUS menu for the current input source:

1.Press and hold the remote control Shift button.

2.While holding the Shift button, press the remote control Stat button. The first page of the STATUS menu for the current input source will appear on the on-screen and front panel displays.

2-17