JBL 201, SDP-5 manual Remote Control Overview, Main Menu, Operation Considerations, Menu Navigation

Basic Operation

JBL Synthesis

REMOTE CONTROL OVERVIEW

The SDP-5 remote control provides full operation of the SDP-5, performing commands such as menu navigation that are not available from the front panel. The command matrix that begins on page 2-13 indicates the commands remote control buttons perform when each command bank is active. The numbered items in the matrix correspond with the remote control illustrations on pages 2-13 to 2-16.

MAIN MENU

The MAIN MENU shown at the right represents the beginning of the menu structure. It can be used to open the three main menu branches: MODE ADJUST, AUDIO CONTROLS, and SETUP. Refer to Sections 5, 4, and 3 for information about these menu branches.

MAIN MENU

MODE ADJUST AUDIO CONTROLS SETUP

OPERATION CONSIDERATIONS

The bulleted items that begin below describe factors that can improve or impede remote control operation. It is recommended to observe these items as well as the battery installation instructions on page 1-5 before operating the remote control.

Please note the following before operating the SDP-5 remote control:

•The remote control must be in line-of-sight with the front panel IR receiver (2-3). Eliminate obstructions between the remote control and the IR receiver. The remote control might become unreliable if strong sunlight or fluorescent light is shining on the IR receiver.

•For optimal performance, position the remote control at a 30 degree angle no more than 17 feet (5m) from the SDP-5. If the SDP-5 is placed inside a glass cabinet, smoked glass will reduce the remote control range.

•Remote controllers for different components can interfere with one another. It is recommended to avoid using remote controls for different components at the same time.

•The remote control batteries should be replaced as needed. Refer to page 1-5 for battery installation instructions.

Refer to the Menu Navigation table on the next page for instructions to open and close the MAIN MENU.

MENU NAVIGATION

The remote control Menu arrows must be used to navigate the extensive menu structure shown in the Appendix (A-4 to A-13). The table on the next page indicates the navigation functions remote control Menu arrows perform when the Main Zone command bank is activated.

MENU ITEM SELECTION

The remote control Menu arrows must be used to select menu items.

To select a menu item on the open menu:

1. Press the remote control Menu and arrows to highlight the desired menu item.

2.When the desired menu item is highlighted, press the Menu arrow to select the highlighted item. If an option is selected, another menu will open. If a parameter is selected, a parameter drop-down menu will open.

2-8