Kodak 9090DC, 9125DC, 9150DC, 9090DB manual Additional print head, Cleaning, Spit pad replacement

Additional print head	If cleaning the print head using the F1 key does not provide the desired
cleaning	results, you can further clean the printer by following the steps below.
	1.	Turn off the scanner.
	2.	Remove the front (or back) imprinter unit from the scanner. See the
		sections entitled, “Removing the front imprinter” or “Removing the
		back imprinter” earlier in this chapter for instructions.
	3.	Remove the ink cartridge by grasping the ink cartridge holder and
		pulling the tab on the ink cartridge out from the ink cartridge holder.

4.Dampen a clean, lint-free cloth with water.

5.Hold the cloth in contact with the nozzles on the ink cartridge for a few seconds, then gently wipe the nozzle plate. Do not wipe the electrical contact area.

6.If ink remains on the nozzle plate, wipe again with a dry, lint-free cloth.

CAUTION: Do not use a roller cleaning pad to clean the print head. Do not use any material that contains alcohol when cleaning the print head.

Spit pad replacement	The back page imprinter assembly contains a spit pad that is used to
	absorb any excess ink from the front page imprinter during printing. The
	spit pad is located underneath the back page assembly’s entry tray.
	Over time the spit pad will become saturated and will need to be
	replaced. The life expectancy of the spit pad is expected to last as long
	or longer than the transport rollers. Contact Technical Support for spit
	pad replacement.

A-61662 October 2011 B-9