Cleaning the transport | Over time, the transport will become dirty and may feed documents | |
| erratically or skew the documents as they enter the scanner. To prevent | |
| erratic feeding, clean the transport every 50,000 pages or as needed. | |
| NOTE: It is recommended that you clean the imaging guides again after | |
|
| cleaning the transport with a transport cleaning sheet. |
| 1. | Establish communication between the scanner and the Ngenuity |
|
| Operator Utility. |
| 2. | Verify that one of the Custom Functions (F1 or F2) is set to Feed |
|
| Test Batch. |
| 3. | Press F1 or F2 key depending on which key is assigned to “Feed |
|
| Test Batch”. This will start the scanner transport. By default, the F1 |
|
| key is assigned the Feed Test Batch function. |
| 4. | Feed the transport cleaning sheet in landscape orientation into the |
|
| scanner transport. |
| 5. | Observe the cleaning sheet, and run it through the transport again, |
|
| changing its position slightly each time, until the tires leave no dark |
|
| streaks. |
| 6. | Turn the transport cleaning sheet over and run it through the |
|
| scanner transport two times. |
| 7. | Press and hold the Pause/Stop button |
|
| scanner stops running. |
| 8. | Press the Clear/Restart button. |
| 9. | When finished, discard the transport cleaning sheet. After running |
|
| the cleaning sheet, inspect the imaging guides. It may be necessary |
|
| to clean off any residue from the cleaning sheet that may be on the |
|
| imaging guides. |
