Removing the front imprinter
10.Connect the imprinter cable to the connector on the imprinter unit noting the orientation of the key on the plug and the slot on the con- nector.
11.Close the imprinter door.
12.Replace the exit tray.
13.Turn on the scanner and the PC.
14.Launch the Ngenuity Operator Utility and confirm the imprinter is recognized.
NOTE: Do not leave the ink cartridge in the imprinter when not in use.
1.Turn off the scanner.
2.Remove the exit tray.
3.Open the front page imprinter door.
4.Unplug the imprinter cable.
5.Unscrew the thumb screw located on the right side of the imprinter.
6.Pull the
7.Lift the imprinter up and out of the scanner.
8.Close the front page imprinter door, reinstall the exit tray and turn on the scanner.
