Class 1 Fax/Modem

Class 1 Fax/Modem

The Class 1 fax/modem interface on your unit enables it to function as a Class 1 fax/ modem for any IBM-compatible computer, sending and receiving fax messages directly from your computer. The Class 1 fax/modem interface works with the computer to increase fax efficiency and speed. It works with the commercially available PC-fax software listed below.

You can also use the interface to scan and print fax resolution quality documents.

The interface works with the following fax software:

•WinFax Pro V4.01

•FaxWorks Pro V3.00A

•Bitfax V3.07

•LaserFax Class 1

It is possible to use other Class 1 computer software, but Lanier doesn’t guarantee their operation.

Note: For software installation, refer to the PC fax vendor documentation.

Class 1 Interface

The Class 1 interface provides these functions:

•Fax transmission. A file in the computer can be faxed directly to a remote location. There is no need to print the file and scan it into the fax unit first. The PC fax software directs the file to your fax unit, and your fax unit sends it to the remote fax location.

•Fax receiving. Your PC can receive a fax from a remote location. The PC-fax software converts the fax into a computer file, and saves it on the computer’s hard drive.

•Printing. You can send a file from your computer to your fax unit. The fax machine receives the file from the computer and prints the document at standard (100 x 200 dpi), fine (200 x 200 dpi), or superfine (200 x 400 dpi) resolution.

•Scanning. See page 7-18.

PC Requirements

Your PC must have an available serial COMM port. The computer type (386, 486, etc.), speed, and memory capacity must meet the system requirements for the PC fax software package you have selected. Refer to the PC fax software documentation for system requirements.

5 - 22

PC Printing & Scanning