Make sure the computer is on.
Make sure the PC-fax software is running and set to auto-answer mode.

Class 1 Fax/Modem

Sending a Fax in Class 1 Mode

Follow these steps to send a fax from your computer to a remote location

1

2

3

From the computer, select the file you are sending.

Enter the remote fax telephone number.

Start the send operation from the PC, according to the PC-fax software instructions.

Receiving a Fax in Class 1 Mode

Note these requirements for receiving a fax on your computer:

•PC RX must be set to ON (see “PC RX mode (ON/OFF) on page 6-35 in Chapter 6 for instructions). (Default = ON)

•The computer must be on.

•The PC-fax software must be running and set to auto-answer.

•Your unit routes the incoming call to the computer.

Scanning in Class 1 Mode

To scan a document from your unit into your PC-fax application, you must use your Class 1 ID number for the destination. You must enter your ID number exactly as it is programmed. (Default = 999)

Instructions for programming the Class 1 ID number are included on a gray, perforated page in this manual. These instructions should be removed from this manual immediately and stored in a secure place to prevent unauthorized use.

Follow these steps to scan a fax into your computer:

1

2

3 Load the document in the ADF.

4 Select the highest available resolution to assure the best print quality.

5 Enter your Class ID number as the destination. Enter this number in one of the following ways:

•Use your MFD keypad to enter your fax phone number.

•Pre-program your fax phone number into a one-touch or speed dial location. Use this one-touch or speed dial to enter the destination.

6 Your unit scans the document into memory, then faxes the document to the computer.

5 - 24

PC Printing & Scanning