Lexmark X746de Copying multiple pages onto a single sheet, Creating a custom copy job job build

Copying 99

•Between Pages

•Off

4Touch > Copy It.

Copying multiple pages onto a single sheet

In order to save paper, you can copy either two or four consecutive pages of a multiple‑page document onto a single sheet of paper.

Notes:

• The Paper Size must be set to Letter, Legal, A4, or JIS B5.

• The Copy Size must be set to 100%.

1 Load an original document faceup, short edge first into the ADF or facedown on the scanner glass.

Note: Do not load postcards, photos, small items, transparencies, photo paper, or thin media (such as magazine clippings) into the ADF. Place these items on the scanner glass.

2If you are loading a document into the ADF, then adjust the paper guides.

3From the home screen, navigate to:

Copy > Advanced Options > Paper Saver > select desired output > > Copy It

Creating a custom copy job (job build)

The custom copy job or job build is used to combine one or more sets of original documents into a single copy job. Each set may be scanned using different job parameters. When a copy job is submitted and Custom Job is enabled, the scanner scans the first set of original documents using the supplied parameters, and then it scans the next set with the same or different parameters.

The definition of a set depends on the scan source:

•If you scan a document on the scanner glass, then a set consists of one page.

•If you scan multiple pages using the ADF, then a set consists of all scanned pages until the ADF becomes empty.

•If you scan one page using the ADF, then a set consists of one page.

For example:

1Load an original document faceup, short edge first into the ADF or facedown on the scanner glass.

Note: Do not load postcards, photos, small items, transparencies, photo paper, or thin media (such as magazine clippings) into the ADF. Place these items on the scanner glass.

2If you are loading a document into the ADF, then adjust the paper guides.

3From the home screen, navigate to:

Copy > Options > Custom Job > On > Done > Copy It When the end of a set is reached, the scan screen appears.