Lucent Technologies 555-230-128 manual Release 6 CMC Modem Fields Description

DEFINITY Enterprise Communications Server Release 6	Issue 3
Installation and Test for Compact Modular Cabinets 555-230-128	May 1998
1 Install and Cable the Cabinets
Connect Modem to Telephone Network	Page 1-99

8.For non-United States installations, set the remaining modem fields as shown in Table 1-20.

9.Press Enter when the modem fields are properly administered.

Table 1-20. Release 6 CMC Modem Fields

Field	Description
Modem	Default is none for Release 6 CMC. Set to external if a modem is used.
Connection
Modem Name	This field is 20 characters long and permits alphanumeric characters to
	provide a unique qualifier for a given modem.
RTS/CTS	Informs modem that communication with the data source UART is driven
Enabled	with RTS/CTS flow control. The default 6-character field name is &H1.
	Set the field name to \Q3 for Intel modems. This field is not
	case-sensitive.
Asynchronous	Configures modem as an asynchronous device. This 8-character field
Data Mode	name has a default value of &M0 (default) for Release 6csi. Set the field
	to &M0&Q0 for Intel modems. This field is not case-sensitive.
DTE	Adjusts the speed of the data source (DTE) UART to the outgoing
Auto-Data	(modem-to-modem) data rate. At maximum, this speed is 9600 baud. It
Speed	is not desirable to have the serial data fill the modem buffer faster than
	the outgoing data rate, since data compression is disabled. The field
	name has a 6-character blank default value. The Paradyne products use
	S90=1 to enable this functionality while the Intel product uses \J1 to
	enable similar functionality. This field is not case-sensitive.
Disable Data	Turns off the default data compression algorithms used by most
Compression	modems. The field has a blank field of 6 characters as default. The AT
	commands that control this are supported by similar commands;
	however, these commands do not operate in the same manner. The Intel
	modems require H0%C0 to disable V.42bis & MNP Class 5 data
	compression algorithms. The Paradyne products only use %C0 to
	disable both algorithms. This field is not case-sensitive.
Enable Error	Turns on the V.42 LAPM and MNP error control protocols. The field has a
Control	blank default of 6 characters. The Paradyne products use the command
	\N5 to enable V.42/MNP/Buffer error control while the Intel product uses
	\N3 to provide similar functionality.
Misc. Init.	This field has a 20-character blank default and supports any initialization
Param	parameters not already specified. The AT commands specified in this
	field are always the last initialization parameters to be sent to the
	external modem. This field is not case-sensitive.

Continued on next page