DEFINITY Enterprise Communications Server Release 6 | Issue 3 |
Installation and Test for Compact Modular Cabinets | May 1998 |
1 Install and Cable the Cabinets |
|
Activate and Administer the System | Page |
|
|
Circuit Pack Administration
After the equipment is installed (including circuit packs), the circuit packs must be administered. Refer to DEFINITY Enterprise Communications Server Release 6 Administration and Feature Description, for more information.
The following describes general administration information:
■Use the Circuit Packs form to administer circuit packs to carrier slots. The circuit packs must be installed (or assigned using the Circuit Packs form) before administering voice terminals, attendant consoles, or trunks.
■Each page of the form represents 1 carrier in the cabinet shown on the command line. For Release 6 CMC, all carriers and slots appear even if they are not included in the hardware.
■It is not necessary to fill in the Circuit Packs form if the circuit packs are installed at the time of administration.
■Refer to DEFINITY Communications System Generic 3 Planning and Configuration,
■For initial installation, assign circuit packs to slots using the hardware configuration layout record from the factory or Customer Services Organization. Do not arbitrarily assign circuit packs to slots.
■When a circuit pack in a slot differs from what has been administered on the form, a “#” displays between the “Sfx” and “Name” fields.
Set System Maintenance Parameters
!
CAUTION:
To prevent unnecessary trouble tickets, do not enable the system alarms (Alarm Origination feature) until all installation and administration procedures are completed.
1.Enter change system-parameters maintenance and press Enter.
2.Enter the alarm notification and scheduled maintenance information into each field on Page 1 of the form.
3.Enter the appropriate information on Page 2 of the form.
4.Page 3 of the form is administered later in this book.
5.Press Enter when finished.
