Copyright © 1999, Lucent Technologies

All Rights Reserved

Printed in U.S.A.

Notice

Every effort was made to ensure that the information in this book was complete and accurate at the time of printing. However, information is subject to change.

Your Responsibility for Your System’s Security

Toll fraud is the unauthorized use of your telecommunications system by an unauthorized party, for example, persons other than your com- pany’s employees, agents, subcontractors, or persons working on your company’s behalf. Note that there may be a risk of toll fraud associated with your telecommunications system and, if toll fraud occurs, it can result in substantial additional charges for your telecommunications services.

You and your system manager are responsible for the security of your system, such as programming and configuring your equipment to pre- vent unauthorized use. The system manager is also responsible for reading all installation, instruction, and system administration docu- ments provided with this product in order to fully understand the fea- tures that can introduce risk of toll fraud and the steps that can be taken to reduce that risk. Lucent Technologies does not warrant that this product is immune from or will prevent unauthorized use of com- mon-carrier telecommunication services or facilities accessed through or connected to it. Lucent Technologies will not be responsible for any charges that result from such unauthorized use.

Lucent Technologies Fraud Intervention

If you suspect that you are being victimized by toll fraud and you need technical support or assistance, call Technical Service Center Toll Fraud Intervention Hotline at 1 800 643-2353.

Federal Communications Commission Statement

Part 15: Class A Statement. This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide rea- sonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio-frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interfer- ence to radio communications. Operation of this equipment in a resi- dential area is likely to cause harmful interference, in which case the user will be required to correct the interference at his own expense.

Part 68: Network Registration Number. This equipment is registered with the FCC in accordance with Part 68 of the FCC Rules. It is identi- fied by FCC registration number AS593M-13283-MF-E. Refer to “Federal Communications Commission Statement” in “About This Book” for more information regarding Part 68.

Canadian Department of Communications (DOC) Interference Information

This digital apparatus does not exceed the Class A limits for radio noise emissions set out in the radio interference regulations of the Canadian Department of Communications.

Le Présent Appareil Nomérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la class A préscrites dans le reglement sur le brouillage radioélectrique édicté par le ministére des Communications du Canada.

Trademarks

DEFINITY is a registered trademark of Lucent Technologies.

Ordering Information

Call: Lucent Technologies BCS Publications Center

Voice 1 800 457-1235 International Voice 317 322-6416

Fax 1 800 457-1764 International Fax 317 322-6699

Write: Lucent Technologies BCS Publications Center 2855 N. Franklin Road

Indianapolis, IN 46219

Order: Document No. 555-230-700 Comcode 108383837 Issue 4, June 1999

For additional documents, refer to the “Introduction.”

You can be placed on a standing order list for this and other documents you may need. Standing order will enable you to automatically receive updated versions of individual documents or document sets, billed to account information that you provide. For more information on stand- ing orders, or to be put on a list to receive future issues of this docu- ment, contact the Lucent Technologies Publications Center.

European Union Declaration of Conformity

The “CE” mark affixed to the DEFINITY® equipment described in

this book indicates that the equipment conforms to the following Euro- pean Union (EU) Directives:

Electromagnetic Compatibility (89/336/EEC)

Low Voltage (73/23/EEC)

Telecommunications Terminal Equipment (TTE) i-CTR3 BRI

and i-CTR4 PRI

For more information on standards compliance, contact your local dis- tributor.

Comments

To comment on this document, return the comment card at the front of the document.

Acknowledgment

This document was prepared by Product Documentation Development, Lucent Technologies, Denver, CO.

Page 2
Image 2
Lucent Technologies Enterprise Communications Server manual Trademarks