2CLI Commands
McDATA OPENconnectors Command Line Interface USER MANUAL P/N 620-000134-300
2-38
FRQILJVZLWFKVSHHG
6\QWD[ speed switchSpeed
3XUSRVH This command sets the speed for the switch.
This command is only applicable for the Intrepid 6064. Sphereon products
cannot change switch speed.
'HVFULSWLRQ The switch must be set offline before this command is entered.
A switch can be configured to operate at 1 Gbps or 2 Gbps.
If the switch has FPM cards, configuring the switch speed to 2Gbps
makes all the ports on the FPM cards inactive, and their operational
state will be set to inactive. FPM ports do not support 2 Gbps and,
therefore, will remain inactive after the switch is returned to the
online state.
3DUDPHWHUV This command has one required parameter.
&RPPDQG([DPSOHV Root> config switch speed 2g
switchSpeed Specifies the speed of the switch. Valid values
are 1g (for 1 Gbps) or 2g (for 2 Gbps).