SNMP Events Table
9 SNMP Events Table
The following table lists all recorded events.
Event Text | Code | Comment |
System Boot | 1010 | Reported upon device |
|
|
|
Server Busy ask | 1030 | Attempt to connect when another user is already connected. The second |
for disconnect. |
| user has permission for takeover; sent before the second user actually |
|
| takes over the session. |
|
|
|
User login | 1040 | On every successful user login to the device. |
succeeded |
|
|
|
|
|
Login failed wrong | 1050 | Login failed due to wrong user name or password. |
user name or |
|
|
password |
|
|
|
|
|
Login not | 1060 | Login denied because a user with higher permission is connected |
succeeded server |
| (takeover not allowed). |
busy |
|
|
|
|
|
Logout | 1070 | User Logout (end of remote access session). |
|
|
|
Disconnected by | 1110 | Takeover has been successfully performed; the previous user has been |
another user |
| disconnected. |
|
|
|
Hardware Failure | 1200 | Device internal hardware failure. Try disconnecting any other attached |
|
| device and reboot. If problem persists, contact technical support. |
|
|
|
Hard reset power | 1220 | Power cycle command issued; only relevant when a special |
cycle command |
| product is attached to the device (for exmple, KBPower). |
|
|
|
Viewer login | 1230 | User connected in |
|
| regular session). |
|
|
|
Viewer logout | 1240 | User connected in |
|
|
|
Global access | 1250 | Device has been blocked for access by an administrator; remote access |
disabled |
| is disabled until the device is unblocked. |
|
|
|
Block User | 1260 | User blocked due to too many login attempts; failure per policy in |
Account |
| configuration. |
|
|
|
Successful User | 2010 | Successful User Login. CONF_USER_EVENT_LOGIN_SUCCEEDED |
Login |
|
|
|
|
|
Login is not | 2020 | Login is not successful – wrong user access level. |
successful – |
| CONF_USER_EVENT_LOGIN_NOT_SUCCEEDED_WRONG_LEVEL |
wrong user access |
|
|
level. |
|
|
|
|
|
