AppendixC Uninstallingthe Hardware and Software
©NationalInstruments Corporation C-21 SerialHardware and Software for Windows
FigureC-12. Selectingan Inte rface to Uninstall
3. ClickontheDeletebutton.
Note Forshared IRQ ATboards, all ports on the interface are removed.
Uninstall the Software
Before uninstalling the software, removeall serial port inform ation from
the WindowsNT Control Panel, as described in the previous section. You
do not need to shut downWindows NT before uninstalling the software.
Completethe following steps to remove the NI-Serial software.
1. Select Start»Settings»Control Panel.
2. Double-clickon the Add/Remove Programs icon in the Control Panel
to launch the Add/RemovePrograms applet . The Add/Remove
Programs Properties dialog box appears. This dialog box lists the
softwareavailable for removal.
3. Select the serial software you want to remove,an dcl ick on the
Add/Remove button.The un install program runs and removes all
folders,utilities, and registry entries associated with the NI-Serial
software.
4. Shut downWindows NT, power off your computer, and removeyour
serialinterfaces.
Toreinstall the hardware and software, refer to Chapter 5, AT Serial
Hardware Installation, Verification, and Configuration.