Index
SerialHardware and Software for Windows I-2 ni.com
commonquestions
changing resources assigned tos erial
interface,D-16
determiningnumber of interrupts required
fora serial interface,D-17, D -23
determining portassociated with COMx
Windows 2000, D-4
Windows Me/9x,D-15
Windows NT, D-22
determining type of serial hardware
installed
Windows 2000, D-4
Windows Me/9x,D-14
Windows NT, D-22
determiningversion of NI-Serial software
installed
Windows 2000, D-4
Windows Me/9x,D-15
Windows NT, D-22
diagnostic test failure
Windows 2000, D-4
Windows Me/9x,D-15
Windows NT, D-22
maximum supported baud rate
Windows 2000, D-5
Windows Me/9x,D-17
Windows NT, D-23
naming National Instruments serial ports
Windows 2000, D-4
Windows Me/9x,D-15
Windows NT, D-22
removinginformation abou t serial boards
from Device Manager
Windows 2000, D-5
Windows Me/9x,D-17
Windows 2000, D-4
Windows Me/9x,D-14
Windows NT, D-22
communication ports ettings
viewing or changing
Windows 2000, 2-5, 3-5, 4-5, 5-5
Windows Me/9x, 2-14, 3-13,
4-13, 5-14
Windows NT, 2-21, 3-20, 4-19, 5-22
ComponentWorks,1-9
ComponentWorks++, 1-9
configuration
resource settings, 5-24
conflict-free resources,D-7
selecting, D-7
connectingcables, A-1
connectingcables to four-port PCI serial board
(figure), A-5
connecting two-wire devices, A-1
conventions, xiii
customereducation, F-1
D
DB-25 connector, A-4
pin descriptions (table), A-4
pin locations (figure), A-4
DB-9
100-pin connector pin descriptions
(figure), A-8
100-pin connector pin descriptions
(table), A-9
68-pin connector pin descriptions
(figure), A-6
68-pin connector pin descriptions
(table), A-7
connector, A-2
pin descriptions (table), A-2
pin locations (figure), A-2
DCE vs. DTE, B-7
default restoration, 2-9, 2-18, 3-9, 3-17, 4-8,
4-16, 5-9
determiningnumber of interrupts required for
a serialinterface, D-23