Using the BayStack 410-24T 10BASE-T Switch

Table 3-36. TELNET Configuration Screen Fields

FieldDescription

TELNET Access Allows remote access to the CI through a TELNET session.

Default Value: Enabled

Login Timeout

Login Retries

Inactivity

Timeout

Event Logging

Range:

Enabled, Disabled

Specifies the amount of time you have to enter the correct password at the console-terminal prompt.

Default Value:

1 minute

Range:

0 to 10 minutes (0 indicates “no timeout”)

Specifies the number of times you can enter an incorrect password at the console-terminal prompt before the session is terminated.

Default Value: 3

Range:

1 to 100

Specifies the amount of time the session can be inactive before it is terminated.

Default Value:

15 minutes

Range:

0 to 60 minutes (0 indicates “no timeout”)

Specifies the types of events that will be displayed in the Event Log screen (see “Display Event Log” on page 3-109).

Default Value: All

Range:

All, None, Accesses, Failures

Description: All: Logs the following TELNET events to the Event Log screen:

TELNET connect: Indicates the IP address and access mode of a TELNET session.

TELNET disconnect: Indicates the IP address of the remote host and the access mode, due to either a logout or inactivity.

Failed TELNET connection attempts: Indicates the IP address of the remote host whose IP address is not on the list of allowed addresses, or indicates the IP address of the remote host that did not supply the correct password.

None: Indicates that no TELNET events will be logged in the Event Log screen.

Accesses: Logs only TELNET connect and disconnect events in the Event Log screen.

Failures: Logs only failed TELNET connection attempts in the Event Log screen.

(continued)

3-100

309985-B Rev 00

Page 238
Image 238
Nortel Networks 24T manual Telnet Configuration Screen Fields, Login Timeout Login Retries Inactivity Event Logging