Nortel Networks 24T manual Stack Configurations, Removing a Unit from the Stack

Introduction to the BayStack 410-24T Switch

Removing a Unit from the Stack

If a unit is removed from the stack (therefore operating in standalone mode), the following switch configuration settings revert back to the settings configured before the unit became a member of the stack:

•IP address

•Console password

•TELNET password

•SNMP community strings

Stack Configurations

As shown in Figure 1-12, the cascade connectors and cables on the 400-ST1 front panel provide the ability to stack up to eight BayStack switches. With 400-4TX MDAs installed in each switch, the stack can accommodate a maximum of 224 switch ports.

Because stack parameters are associated with the base unit (see “Initial Installation” on page 1-29), the physical stack order depends on the base unit’s position and whether the stack is configured stack up or stack down.

309985-B Rev 00 1-31