4. Operation
Using the Setup Menu
9.Press TAKE to activate the other scaler.
10.Repeat steps 7 and 8 for the other scaler.
11.Press ESC to return to the Input Menu.
12.Scroll to the Save Config line, and press SEL to save the configuration for the selected input.
13.Repeat the entire adjustment procedure from step 1, for all remaining inputs whose “type” is analog — and be sure to save the input configuration each time you complete an adjustment for a selected input.
fã~ÖÉ=^Çàìëí
From the Input Menu, select Image Adjust to display the Image Adjust Menu. This menu, shown in the following illustration, enables you to adjust input parameters such as horizontal and vertical image size, pan and aspect ratio:
|
|
|
|
| IMAGE ADJUST |
|
|
| > Auto Config |
|
|
| H Size | 0 |
|
| V Size | 0 |
|
| H Pan | [0] |
|
| V Pan | [0] |
|
| Aspect Ratio | 4:3 |
|
| Reset All |
|
|
|
|
|
|
Figure 4-26. Image Adjust Menu (sample)
Note
It is recommended that you use the Image Adjust Menu only when you are using DVI, SDI, NTSC or PAL input sources. For analog input sources (except NTSC and PAL), refer to the “Timing Adjust” section on page 57.
Select Auto Config to perform an automatic input configuration on an NTSC or PAL source on Program. The system finds the first and last pixel on each edge, and ensures (to the best possible extent) that the entire image is visible. In addition, the system automatically phases the input to determine the correct sampling phase.
Note
The Auto Config selection is only available for analog inputs (NTSC or PAL). This function is identical to the Auto Config function in the Timing Adjust Menu.
The Size and Pan functions allow you to size the image, and then position it within the selected aspect ratio. The
•Select H Size to size both the left and right edges simultaneously. Values are in pixels. The output “window” is maintained in both size and aspect ratio.
60 |
|
|
|
