2. Hardware Orientation

DCS-200 Rear Panel

3)HD/SD SDI Input

One BNC connector is provided for the SD-SDI or HD-SDI input.

4)Main Outputs

Two connectors are provided for the DCS-200’s main program outputs. Both outputs have the same resolution, and both can be used simultaneously.

~One DVI-I connector is provided for the system’s digital program output. There are no analog outputs on this connector. In Appendix A, refer to the DVI-I Connector” section on page 119 for pinouts.

Note

The DVI-I connector allows you to use both DVI-Dand DVI-Icables as required.

~One HD-15 connector is provided for the system’s analog output. In Appendix A, refer to the “Analog 15-pin D Connector” section on page 118 for pinouts

5)Serial

One DB-9 connector is provided for Serial communications with the DCS-200 system. The port is also used for diagnostics or command-line operations.

6)Ethernet

One RJ-45 connector is provided for 10/100BaseT Ethernet communications with the DCS-200 system. The port is used for running the built-in web-based GUI, for diagnostics, or for command-line operations via Telnet (using port 23).

Stelnet 192.168.0.10 23

In Appendix A, refer to the “Ethernet Connector” section on page 120 for pinouts.

7)AC Power

One AC Connector is provided for connecting DCS-200 to AC. The integral switch turns the chassis on and off. In Appendix A, refer to the “Physical and Electrical Specifications” section on page 117 for power details.

8)Preview Outputs

Two outputs are provided for connecting to the Preview monitor: an HD-15 connector for analog monitors and a DVI connector for digital displays.

26

 

DCS-200 • User’s Guide

 

Page 26
Image 26
Barco DCS-200 manual HD/SD SDI Input, Main Outputs, Serial, Ethernet, AC Power, Preview Outputs