Barco DCS-200 manual Lìíéìí=cçêã~í, QÉëí=m~ííÉêå, Test Patterns, Mode Type Burst Raster Box, Off

4. Operation

Using the Setup Menu

Following are descriptions of each Output Menu function:

•

•

•

•

•

Output Format

Test Pattern

Sync Setup

Gamma

Save Output Config

lìíéìí=cçêã~í

From the Output Menu, select the top Output Format line to view or change the current output format. This line indicates the format in the following form:

Hact x Vact @ Vr Hz

The output format for the DCS-200 can be set to any of the progressive outputs in the format table. In Appendix A, refer to the “Format Table” section on page 122 for details.

Note

The output format is not updated until SEL is pressed.

qÉëí=m~ííÉêå

From the Output Menu, select Test Pattern to display the Test Patterns Menu:

TEST PATTERNS
> Mode	ON
Type	Burst
Raster Box	OFF

Figure 4-13.Test Patterns Menu (sample)

The following functions are available on the menu:

•Mode — This function enables or disables the test pattern generator.

•Type — This function enables you to select a test pattern. Available choices are:

~	H Ramp	~	Gray Steps 1
~	V Ramp	~	Gray Steps 2
~	100% Col Bars	~	Red
~	75% Col bars	~	Green
~ 16 x 16 Grid		~	Blue
~ 32 x 32 Grid		~	White
~	Burst	~	Black

~50% Gray

48 DCS-200 • User’s Guide