Barco manual QêçìÄäÉëÜççíáåÖ=bíÜÉêåÉí=`çããìåáÅ~íáçå, DCS-200 User’s Guide 113

6. Upgrading Software

Ethernet Upgrade Method

qêçìÄäÉëÜççíáåÖ=bíÜÉêåÉí=`çããìåáÅ~íáçå

„Use the following steps to determine the IP address of the DCS-200, and establish proper communications:

1.Power-up the DCS-200.

2.Note the DCS-200’s current IP address:

a.From the Status Menu, press SEL to display the Setup Menu.

b.Select System to display the System Menu.

c.Select Ethernet to display the Ethernet Menu.

d.Make a note of the information on the IP line, which shows the current IP address in all modes (with DHCP on or off).

3.Attempt to ping the DCS-200 as follows:

a.Connect the DCS-200’s Ethernet port to a Switch.

b.Connect the Ethernet Switch to your PC.

c.Turn on the PC or laptop.

d.Open a command prompt window on the PC. Click Start > Programs > Accessories > Command Prompt.

e.On the command prompt line, type: ping 192.168.0.10

... followed by Enter.

Note	Use the unit’s actual IP address, as determined in step 2
	above.

f.If the computer can successfully communicate with the DCS-200, you will see a series of “replies” from the target IP address. Repeat the upgrade procedure as outlined in the “Ethernet Upgrade Method” section on page 110.

g.If you see a “Request timed out” message, the PC is unable to locate the DCS-200. If this is the case:

•Check your network connections and settings as described above, or ...

•Contact your network administrator, or ...

•Contact Technical Support. In Appendix C, refer to the “Contact Information” section on page 160 for details.

DCS-200 • User’s Guide 113