Barco DCS-200 manual `pJOMM=oÉ~ê=m~åÉä, Following are descriptions of each rear panel connector

2. Hardware Orientation

DCS-200 Rear Panel

a`pJOMM=oÉ~ê=m~åÉä

The figure below illustrates the DCS-200 rear panel:

Input 1	Input 3	Input 5	VIDEO INPUTS	MAIN OUTPUTS
				HD/SD SDI
Input 2	Input 4	Input 6	Input 7	Input 8

8

PREVIEW OUTPUTS
SERIAL	ETHERNET

Model

DCS-200

100 - 240 VAC

50 – 60 Hz, 1.9A

	1	2	3	4	5	6	7
	Figure 2-1.DCS-200 Rear Panel
1)	Analog Inputs	4)	Main Outputs		7)	AC Power
2)	DVI and Analog Inputs	5)	Serial		8)	Preview Outputs
3)	HD/SD SDI Input	6)	Ethernet

Following are descriptions of each rear panel connector:

1)Analog Inputs

Six HD-15 connectors are provided for the system’s Analog inputs. Please note:

~Each input provides 10-bits/color sampling at a maximum 165 MHz.

~Each input supports 1:1 sampling up to 1600x1200@60 Hz. Sources with native pixel rates greater than 165 MHz will be filtered and undersampled at 165 Mhz. These include:

•1920x1080p@60 (173.0 MHz)

•1920x1200@60 (193.25 MHz)

•2048x1080p@60 (183.75 MHz)

~Composite and S-Video formats are supported.

In Chapter 3, refer to the “Format Connection Table” section on page 32 for a table of analog inputs that you can connect using a customer-supplied breakout cable. In Appendix A, refer to the “Analog 15-pin D Connector” section on page 118 for pinouts.

2)DVI and Analog Inputs

Two DVI-I connectors are provided for both digital and analog inputs.

~Using the connector’s digital pins, an 8-bit digital input is supported.

~Using the connector’s analog pins, RGBHV, analog composite, S-Video, and YUV formats are supported. A customer-supplied breakout cable or DVI to HD-15adapter is required for these connections.

In Appendix A, refer to the “DVI-I Connector” section on page 119 for pinouts.

DCS-200 • User’s Guide 25