Barco DCS-200 manual Drf=`çååÉÅíáçå=~åÇ=i~ìåÅÜ, Address bar with sample IP address

5. GUI Operations

GUI Connection and Launch

drf=`çååÉÅíáçå=~åÇ=i~ìåÅÜ

„Use the following steps to connect a PC or laptop, and launch the GUI:

1.Ensure that your PC (or laptop) uses Windows® 2000 or Windows XP.

2.Ensure that your PC (or laptop) has a web browser installed, such as Windows Internet Explorer® or Mozilla Firefox®.

3.Ensure that your PC (or laptop) uses Java Version 6 or later.

4.Connect the DCS-200’s Ethernet port to a Switch.

5.Connect the Switch to your PC (or laptop).

6.Power-up the DCS-200.

7.Note the DCS-200’s current IP address:

a.From the Status Menu, press SEL to display the Setup Menu.

b.Select System to display the System Menu.

c.Select Ethernet to display the Ethernet Menu.

d.Make a note of the information on the IP line, which shows the current IP address in all modes (with DHCP on or off).

Note

The default IP address is 192.168.0.10.

8.On your PC (or laptop), open up a web browser.

9.In the browser’s address bar, enter the DCS-200’s IP address as shown in the following illustration.

Figure 5-1.Address bar with sample IP address

Note

Avoid using leading zeros in the IP address. If your display panel shows 192.168.000.010, for example, type the address as shown in the preceding illustration, not as shown on the display.

104 DCS-200 • User’s Guide