4. Operation
Using Keys
hÉó=^ìíç=q~âÉ=lå
When the “Key Auto Take” function is ON in the User Preference Menu, you do not need to press TAKE to perform a key transition. The transition occurs immediately, once the KEY button is pressed. In addition, if a source is pending, it remains pending after the transition. There is no
Use the following steps to mix a key up or down, when Key Auto Take is ON:
1.Press KEY. The system immediately mixes the key up or down, at the current transition rate. Please note:
~If the transition is a “key up,” the KEY button blinks fast during the transition interval, then lights solid when the key is fully on Program.
~If the transition is a “key down,” the KEY button blinks fast during the transition, then automatically turns off when the key is off Program.
Note
If Menu Context is ON, the Key Setup Menu appears when you press KEY, enabling you to change the key source or adjust properties. However, because Key Auto Take is ON, parameters cannot be adjusted until the transition is over.
Refer to the “Key Transition Combinations” section on page 97 for descriptions of the many key combinations that can be performed with the
hÉó=qê~åëáíáçå=`çãÄáå~íáçåë
In this section, brief instructions are provided for each individual key transition. Please remember the following points:
•If Menu Context is ON, the Key Setup Menu appears when the KEY button is pressed.
•Key Clip, Gain, Opacity, H offset and V offset can only be adjusted when the key is visible on Program. The Key Input field, however, can only be changed when the key is off Program. Once the key is on, the Input field is bracketed.
•Whenever TAKE is pressed, the current Program source and the pending program source will
The following combinations are described:
•
•
•
•
•
•
•
Mix Key Up Mix Key Down
Mix Source plus Key Up Mix Source plus Key Down Source Transition Under Key
Fade to Black from Source plus Key Fade up from Black to Source plus Key
| 97 | |
|
