
SDI |
LOGO |
2. Hardware Orientation
•The SDI button selects the
•The LOGO button selects the stored “full screen” LOGO image for the next transition. If no image is stored, the transition will be to Black. Use the menu to select one of three stored LOGOs for use. In Chapter 4, refer to the “Using the LOGO” section on page 88 for details.
Note | If you press a button in the Inputs Section, it blinks to |
| indicate “pending.” If you do not want to pend a source |
| (which may be desirable in some situations), press the |
| blinking source button again. The button turns off, leaving |
| only the source on Program lit solid. |
|
|
FRZ |
BLACK |
bÑÑÉÅíë=pÉÅíáçå
The figure below illustrates the Effects Section:
| Effects |
|
FRZ | BLACK | KEY |
Figure 2-5. Effects Section
The buttons in the Effects Section enable you to freeze the selected source on Program, transition to black, and perform a key over the selected Program source.
Following are descriptions of each “effects” button:
•The FRZ button instantly freezes and unfreezes the current Program source. When the source is frozen, the button is lit solid. In Chapter 4, refer to the “Using Freeze” section on page 92 for details.
•The BLACK button enables you to transition to or from black. The button performs one of two functions, depending on the way the button is defined in the User Preferences Menu.
~If “Black Auto Take” is Off:
•Press BLACK to pend a transition to or from black. The button blinks to indicate “pending.”
•Press TAKE to perform the transition to or from black.
–If the transition is “to” black, the button lights solid when black is on Program.
–If the transition is “from” black, the button turns off when the selected source is fully on Program.
|
| 23 |
|