Barco DCS-200 manual Lìíéìí=pêÅ, Lìíéìí=cçêã~í=EmêÉîáÉïF

4. Operation

Using the Setup Menu

The following sections provide detailed information about Preview Menu functions:

• Output Src	• Preview Sync
• Output Format (Preview)	• Save (Preview)
•Test Patterns (Preview)

lìíéìí=pêÅ

In the Preview Menu, choose Output Src to select the source to be displayed on the preview monitor. The source can be either Preview or Program.

•

•

Choose Preview to display on the preview monitor the “pending” source.

Choose Program to display on the preview monitor the same source that is on Program.

Important

In Preview mode, when you press KEY to “pend” the key transition, you will not see the key overlay on the preview monitor. If you then press TAKE, the input and key appear on Program.

To see the key on the preview monitor, you can route the source from Program to preview using the Output Src selection of the Preview Menu. This selection places a copy of the Program image on the preview monitor, including the key. For more information about keys, see the “Using Keys” section on page 95.

lìíéìí=cçêã~í=EmêÉîáÉïF

In the Preview Menu, the [output_format] field displays the format of the output, in the following form:

Hact x Vact @ Vr Hz

S1024x768@59.94

The output format for the DCS-200 can be set to any of the progressive outputs in the format table. In Appendix A, refer to the “Format Table” section on page 122 for details.

Note

The output format is not updated until you press SEL.

To make pixel-for-pixel adjustments, set the Preview and Program resolutions to be the same, as shown in the following illustration:

Figure 4-18.Matching Preview and Program Resolutions

If you do not need to make pixel-perfect adjustments to the Preview image, the resolutions of the Preview and Program outputs do not need to be the same, as shown in the following

DCS-200 • User’s Guide 51