Barco manual cäáéJÑäçé=jçÇÉ, Operation, DCS-200 User’s Guide, Sources before TAKE

4. Operation

Using Inputs

•For information about using the system in conjunction with HDCP inputs, refer to the “Using HDCP” section on page 86.

cäáéJÑäçé=jçÇÉ

Whenever you press TAKE to mix between inputs (including the LOGO), the DCS-200 automatically flip-flops inputs. Two actions occur when TAKE is pressed:

•The blinking “next” source transitions to Program. Once it is fully on Program, the button lights solid.

•The previous (solid) source on Program automatically becomes the pending “next” source, and the button blinks.

	Program		Pending
	(solid)		(blinking)		Inputs
1	2	3	4	5	6	7	8	SDI	LOGO

Sources before TAKE

	Pending		Program
	(blinking)		(solid)		Inputs
1	2	3	4	5	6	7	8	SDI	LOGO

Sources after TAKE

Figure 4-60.Flip-flop mode, before and after TAKE

Repeatedly pressing TAKE continues to flip-flop the current and pending sources in this manner. Please note:

•

•

•

•

If Black Auto Take is OFF (in the User Preference Menu), you must press TAKE to transition to black. If a source is pending, the source flip-flops to Program — after the system is fully in black.

If Black Auto Take is ON, simply press BLACK to transition to black. If a source is pending, it remains pending after the transition. There is no flip-flop.

If Key Auto Take is OFF (in the User Preference Menu), you must press TAKE to transition the key up or down. If a source is pending, you will transition to the new source and add the key, and the new source flip-flops to Program.

If Key Auto Take is ON, simply press KEY to transition the key up or down. If a source is pending, it remains pending after the transition. There is no flip-flop.

DCS-200 • User’s Guide 85