Barco DCS-200 qÉÅÜ=pìééçêí, c~Åíçêó=oÉëÉí, Operation, Save System Cfg? SEL = Yes ESC = No, 01.00

4. Operation

Using the Setup Menu

•If you do not perform the Save System State function, data will not be restored upon the next system power up sequence.

•If you make a change in the System Menu and attempt to exit the menu (by pressing ESC) without saving changes, the system displays the following prompt::

Save System Cfg?

<SEL> = Yes

<ESC> = No

Figure 4-57.Save System Configuration Prompt

~

~

Select Yes (SEL) to save changes.

Select No (ESC) to continue operation without saving the changes.

qÉÅÜ=pìééçêí

From the Setup Menu, select Tech Support to display the Tech Support Menu:

TECH SUPPORT
Version		01.00
Phone	866-374	-7878

Figure 4-58.Tech Support Menu

The Tech Support Menu displays the following information:

•Version — displays the current version of installed operating firmware. This number changes when you update system software. In Chapter 6, refer to the “Software Upgrade Overview” section on page 108 for update instructions.

•Phone — lists the technical support phone number.

c~Åíçêó=oÉëÉí

From the Main Menu, select Factory Reset to display the Factory Reset Menu:

Clear All Saved

Configurations?

<SEL> = Yes

<ESC> = No

Figure 4-59.Factory Reset Menu

This function enables you to reset the DCS-200 to its factory default condition, in which all user-defined input, output and system configuration files are deleted. When the command is executed, a confirmation menu is shown.

82 DCS-200 • User’s Guide