Nortel Networks 24T manual Vlan Port Configuration Screen Fields

Using the BayStack 410-24T 10BASE-T Switch

Table 3-16. VLAN Port Configuration Screen Fields (continued)

Field	Description
Filter Untagged Frames	Sets this port to filter (discard) all received untagged frames.
	Restriction: If this port is a gigabit port or a port that is a protocol-based
	VLAN member, you cannot set this field value to No. This restriction also
	applies if this port is a trunk member with a gigabit port or a port that is a
	protocol-based VLAN member.
	Default	No
	Range	No, Yes
Filter Unregistered Frames	Sets this port to filter (discard) all received unregistered packets.
	Default	No
	Range	No, Yes
Port Name	The default port name (with associated stack unit number when
	configured) assigned to this port. You can change this field to any name
	that is up to 16 characters long.
	Default	Unit x, Port x
	Range	Any ASCII string of up to 16 printable characters
PVID	Associates this port with a specific VLAN. For example, a port with a
	PVID of 3 assigns all untagged frames received on this port to VLAN 3.
	Default	1
	Range	1 to 4094
Port Priority	Prioritizes the order in which the switch forwards packets received on
	specified ports (see “IEEE 802.1p Prioritizing” on page 1-57).
	Default	0
	Range	0 to 7
Tagging	Allows you to assign VLAN Port Membership tagging options to this port,
	as follows:

• Untagged Access: Any VLAN that this port is a member of will not be 802.1Q tagged.

• Tagged Trunk: Any VLAN that this port is a member of will be 802.1Q tagged.

Restriction: If this port is a gigabit port or a port that is a protocol-based VLAN member, you cannot set this field value to Untagged Access. This restriction also applies if this port is a trunk member with a gigabit port or a port that is a protocol-based VLAN member.

(continued)

3-48 309985-B Rev 00