7.Using the Unitool Printer Driver
7.1Setting Slip Paper in the Paper Tray
This section describes the method to set Slip paper in the input bin. With this printer, the position of the Paper Guide can be adjusted sideways, enabling you to change the paper setting position. If you use this printer driver, however, follow the procedure below when determining the right/left margins for paper and the position to set the Slip paper. Some examples and cautionary notes for use are provided below.
In normal operation, push the Paper Guide for Slip toward the right against the Slip Tray when using this printer driver. (Slide the Paper Guide toward the left as needed, to change the printing area on the paper. For more details, refer to “7.1.1 Using Registered Paper Icons.”)
The first 25.4 mm (1.0") along the right side of the paper is not printable; therefore, set the right margin at 27.94 mm (1.1") or more in normal operation. This printing area is outlined below.
1Printing area
2Left Margin 2.54mm [0.1 inch] or more
3Right Margin 27.94mm [1.1 inch] or more
4Printing disabled area 25.4mm [1.0 inch]
5Printable Maximum Width 160.02mm [6.3 inch]
The maximum printable width per line with Slip paper is 160.02mm(6.3"). The following two types of paper are usable for Slip.
-Paper sizes that are registered as an Icon in Paper Properties/Paper Tab/Paper Size.
-Custom Size
As each paper size is used differently, refer to the various paper setups described in 7.4 and after.
