4.1.1 Details of Alarm Indications
No. of times LED 1 blinks
1
2
3
4
5
6
7
8
9
10
11
12
13
14
Malfunction contents
Program ROM Alarm
EEPROM Alarm
Internal RAM Alarm
External RAM Alarm
Homing Alarm
Spacing Alarm
Auto Cutter Alarm
Platen Switching Alarm
Head A/D Error
WDT (F/T Control)
NMI (F/W Control)
BRK (F/W Control)
MICR Unit Error (only with MICR type)
Interface PCB Error (only OKI standard type)
What you should do
Contact the store where you bought the printer or the Maintenance Service Center
Is the media jammed?
→If it is, remove the jammed paper. Is the ribbon snagged?
→Replace the ribbon.
If the above do not apply to your case, contact the store where you bought the printer or the Maintenance Service Center
Is a piece of paper jammed in the paper passage of the Auto Cutter?
Caution: The Auto Cutter blade is very sharp — do not touch it.
→Turn off the printer, then remove the jammed paper. Be careful not to touch the blade.
If there is no jammed paper, contact your service department or retailer.
Is the media jammed?
→If it is, remove the jammed paper.
If this is not the case, contact the store where you bought the printer or Maintenance Service Center
Contact the store where you bought the printer or Maintenance Service Center
Although the MICR Option is not installed in your printer, is the No. 2 MICR Unit setting in the Menu “Yes?” (On how to check the Menu Settings, refer to Section 2.3, “Menu Function.”
→If it is, change it to “No.”
If this is not the case, contact the store where you bought the printer or Maintenance Service Center
Is I/F board (option) installed correctly?
→If not, install it correctly.
Isn’t I/F board (option) defective?
→If it is, replace the I/F board.
If the above do not apply to your case, contact the store where you bought the printer or Maintenance Service Center
1One Cycle
