Chapter 4 Settings — [SIGNAL LIST] menu

[SIGNAL LIST] menu

On the menu screen, select [SIGNAL LIST] from the main menu.

Refer to “Navigating through the menu” (x page 59) for the operation of the menu screen.

rrRegistered signal details

Memory number: A1 (1-2)

Sub memory number

When the address number (A1, A2, ... L7, L8) signal is registered

ff A name can be set for each sub memory (x page 117).

Registering new signals

After a new signal is input and the <MENU> button on the remote control or the control panel is pressed, the registration is completed and the [MAIN MENU] screen is displayed.

Note

ff Up to 96 signals, including sub memories, can be registered to the projector.

ff There are 12 pages (eight memories of A through L, with eight memories possible on each page) for memory numbers, and the signal is registered to the lowest number that is available. If there is no available memory number it will be overwritten from the oldest signal.

ff The names to be registered are automatically determined by the input signals and memory numbers. ff If a menu is being displayed, the new signals will be registered at the instant they are input.

Renaming the registered signal

Registered signals can be renamed.

1)Press asqw to select the signal of which name is to be changed.

2)Press the <ENTER> button.

ff The [REGISTERED SIGNAL STATUS] screen is displayed.

ff The memory number, input terminal, input signal name, frequency, synch polarity, etc., are displayed. ff Press the <MENU> button to return to the [SIGNAL LIST] screen.

3)Press the <ENTER> button.

ff The [REGISTERED SIGNAL SETUP] screen is displayed.

4)Press as to select [SIGNAL NAME CHANGE].

5)Press the <ENTER> button.

ff The [SIGNAL NAME CHANGE] screen is displayed.

6)Press asqw to select the text, and press the <ENTER> button to enter the text.

7)After the name is changed, press asqw to select [OK], and press the <ENTER> button.

ff The registration is completed and the [REGISTERED SIGNAL SETUP] screen returns.

ff When pressing asqw to select [CANCEL] and pressing the <ENTER> button, the changed signal name will not be registered and an automatically registered signal name will be used.

Deleting the registered signal

Registered signals can be deleted.

1)Press asqw to select the signal to delete.

2)Press the <DEFAULT> button on the remote control.

ff The [ENTRY SIGNAL DELETE] screen is displayed.

ENGLISH - 115